Or facade will be inside the module, or it will be superimposed on the module two ways. Types of accommodation in different types of facades loops are shown in (Fig. 7). Independent loop so as polunakladnye and can be used to that-be on one side wall has two facades. The only thing that facade on the loose hinges must use stops that-be are not the facade fell into a module and thus does not break out of the loop.
Externally polunakladnye and removable hinge loops are very similar but have slightly different izgib.U deposit it more. On (Fig. 8) Middle – , distant – Inserted. 2.Petli transformers are essentially superimposed, their only difference is that the hinge allows you to open the facade at 170 degrees instead of 90. On (Fig. 10 September 1911) Loop tarnsformer in different states – closed, intermediate, open.
3. Angular loop as it is clear from its title are meant for the corner modules, whose facade is relative to the other is located at any angle as acute (Fig. 12) and blunt (Fig. 13). Teneo oftentimes addresses this issue. Are finite and non-standard modules with different angles, in such cases, a loop with an adjustable angle mounting pad (Fig. 14) or with special gaskets made in the form of wedges under different angles of opening. It should be noted that I have described sdes only the most common types of furniture hinges, while the principle remains the same-their variety is amazing. Therefore, all covered of course not possible. Now some will tell you about the method of attachment of furniture hinges. The most common is that in the facade by Forstner drill bit (Fig. 16), drill a hole with a diameter of 35 mm, certainly not through-and-so would there fit the bowl of the loop. A module is screwed to the sidewall of the mounting area after which the two parts (part of) the loops are connected and tightened mounting screws. After a hitch in the front need to adjust performed in three dimensions. (See Figure 15). So is there a loop when installing which Forstner drill bit is needed. On (Fig. 17) the loop intended for glass facades without the frame. On (Fig. 18) shows the size bill loop does not require . On (Fig. 19) Figure loop intended for glass facades with aluminum frame.