Resin on one side penetrates into the surface of the plate, on the other hand is squeezed out and hardens, creating a decorative and protective layer. This provides a strong connection plates and paper, and is the face of the lamination. This process is completely absent adhesive. Lamination plates are usually made in factories chipboard or large furniture factories. These factories make the lining plate has a specific size, according to customer's specification, which allows production of elements furniture lined edges. In this case, there is no product in the joints between the front surface and edges. Italian manufacturers are widely used for the production of laminated boards or create furniture composition, where the carcass and fronts are made of a laminate, as part of the facades are made of veneer.
Plastic Alternative names: Plastic surface, lining paper and laminate, layered polymer plastic. It is used in the manufacture of: Frame furniture and kitchens, kitchen fronts, countertops, tables. General characteristics. Paper Laminates are produced by hot pressing layers of paper impregnated with resins. The thickness of the plastic depends on the number of layers of paper sheets. The external decorative layer is made of high-quality monochrome paper or paper with a printed pattern. The inner layers are made of kraft paper.
In the present expensive plastic hard protective outer layer of transparent overlay paper impregnated with resin. Properties: high hardness and strength, resistance to temperatures and detergents; Water resistant. Furniture made of plastic, usually has a straight form, without recesses. The process of lining. For particleboard glued paper and laminate and cured under pressure. Painted MDF Alternative names: MDF coated with enamel. It is used in the manufacture of: Facade and kitchen furniture, cabinets, backs beds, bath, table tops, frames the elements of upholstered furniture. General characteristics. The quality and environmental painted MDF used affect the enamel, varnish and paint conditions. For painting of furniture Italian factories produce polyurethane enamel specifically designed for residential applications. Properties. If you are painting quality materials used, the result has a high moisture-resistant MDF, temperature resistance and moderate resistance to mechanical damage (scratches). The process of lining: Preparation surface of the MDF Multiple coats of primers; Painting polyester or polyurethane enamel Clearcoat and polishing. Film MDF : Film MDF, Foil. It is used in the manufacture of: Facades of kitchens and furniture. General characteristics. PVC film – a film based on polyvinyl chloride. PVC film is made only of rigid PVC which contains no volatile plasticizers. Material properties: Good moisture resistance, moderate resistance to mechanical and thermal effects. Long-term thermal effects (lights, leaky oven, kettle, which is overlooked not use) can lead to damage to the facade. The process of lining. The polymer film is pressed on the wood stove, where glue coating. The process is carried out in a vacuum press. When the temperature effects of the film is heated, stretches and fits snugly to the surface of MDF. Conclusion If the furniture is chosen for the living room, the inner material (the basis of structural elements) from a practical point of view is not so principled. From the standpoint of sustainability and durability of the more important is the quality of coating and processing quality of the edges. Therefore, it is for lining the edges and in the Italian furniture industry subject to special requirements. Italian furniture is made with all these standards, in particular, and explains the confession, which she won by consumers in Europe and the USA.